|
Post by nzwatchdoctor on Dec 10, 2022 21:35:40 GMT -8
I got one of these from a good customer / friend for a replacement stem.
It's the real deal with the eagle and Swastika on the back etc.
He got it with a broken stem. I couldn't id the movement so sent it to a friend who's a better watchmaker than me (not hard to do...) and he's managed to find a stem and modify it to fit.
The problem now - part of the stem is sticking out from the crown but it won't unwind - even in his lathe. I'll give it a soak in a solution and try again but we're not hopeful.
If I can't get it off getting another crown will be difficult (screw down) and it won't have the patina that the case etc has - not worn - just a nicely aged colour.
|
|
|
Post by russtmurray on Dec 14, 2022 18:38:20 GMT -8
Care to share a photo?
|
|
scubarob99
Moderator
Just bought a 6309-7049...this is the last one, I promise.
Posts: 3,701
|
Post by scubarob99 on Dec 16, 2022 4:37:13 GMT -8
Let's stay away from any Nazi memorabilia photos
Rob
|
|
|
Post by russtmurray on Dec 16, 2022 8:43:53 GMT -8
Let's stay away from any Nazi memorabilia photos Rob No problem here.
|
|
|
Post by nzwatchdoctor on Dec 17, 2022 20:43:22 GMT -8
Let's stay away from any Nazi memorabilia photos Rob No problem here. Or here apart from I've not got it back yet and I have to post photos to a third party - Quram(?) which is a bit annoying to do.
|
|
trilo
WS Benefactor
Posts: 1,995
|
Post by trilo on Dec 19, 2022 3:29:46 GMT -8
Boil or heat the crown.
If it's been glued, boiling should in most cases brake the bond, but wont damage the gasket.
If boiling doesn't help, try heating the crown with a clean flame. I recommend removing the gasket first, so that it doesn't melt and then put a new one in later.
|
|
|
Post by nzwatchdoctor on Dec 21, 2022 7:12:09 GMT -8
Boil or heat the crown. If it's been glued, boiling should in most cases brake the bond, but wont damage the gasket. If boiling doesn't help, try heating the crown with a clean flame. I recommend removing the gasket first, so that it doesn't melt and then put a new one in later. Thanks for these suggestions. I'll try them.
|
|