|
|
Post by earthphase on Oct 4, 2016 10:36:35 GMT -8
Hi - will the MM300 dial fit smoothly into any of the lower end divers?
Thanks.
|
|
Myles
Needs a Life!
Posts: 2,059 
|
Post by Myles on Oct 4, 2016 11:11:32 GMT -8
Hi - will the MM300 dial fit smoothly into any of the lower end divers? Thanks. Nope. The dial feet are in the wrong position. |
|
|
|
Post by earthphase on Oct 4, 2016 11:13:40 GMT -8
Thanks Myles... One more for you - you may know. Would an SKX173 dated to 1995 (serial 550388) have the same lume as say a 2010 or later? Hi - will the MM300 dial fit smoothly into any of the lower end divers? Thanks. Nope. The dial feet are in the wrong position. |
|
Myles
Needs a Life!
Posts: 2,059
|
Post by Myles on Oct 4, 2016 11:17:44 GMT -8
Thanks Myles... One more for you - you may know. Would an SKX173 dated to 1995 (serial 550388) have the same lume as say a 2010 or later? Nope. The dial feet are in the wrong position. I can't say for sure, but I'm pretty sure all of the 7S26-002* dials were done with Lumi Brite. I think some of the earlier 7002 diver dials had promethium-laced luminous compound. |
|
Mr.Jones
Needs a Life!
Hamburg, Germany
Posts: 4,679
|
Post by Mr.Jones on Oct 4, 2016 13:00:00 GMT -8
Wasn't the 7S26 introduced in 1996? A 55xxxx serial would be 2005, no?
|
|
cd_god
Is a Permanent Fixture
Finna set up a HOOD next door to your richie phuk suburban mansion
Posts: 12,302
|
Post by cd_god on Oct 4, 2016 16:18:34 GMT -8
Would an SKX173 dated to 1995 (serial 550388) have the same lume as say a 2010 or later? Probably no difference but if you are buying a whole watch the odds of a 2010 or later NOT needing a service would be a whole lot greater than an older one. IF the movement is a 7S26A then it is from the 90's, if it is a B it is from the mid 2000's, and if it is a C it is from the early 2010's to date. |
|
Adrian-VTA
Global Moderator
Adelaide, South Australia
Posts: 5,327
|
Post by Adrian-VTA on Oct 4, 2016 22:33:15 GMT -8
Should be the same lume. They all went lumi brite after the crappy 7002 lume. The only differences would be patina. Thanks Myles... One more for you - you may know. Would an SKX173 dated to 1995 (serial 550388) have the same lume as say a 2010 or later? Nope. The dial feet are in the wrong position. |
|
